Before the wax sculpture is made, the sculpture is first made into a skeleton with a sculpture shape. After the sculpture skeleton is completed, a cylindrical clay strip is drawn between the palms, and the mud strip is gently pressed around the skeleton pillar, one at a time. To make the cylindrical shape of the neck. Note that it is not the flattening of the mud around the skeleton. Continue to shape the body with the mud strips to unfold the basic shape of the head block. When adding the clay block, the clay block should be placed vertically to shape the front and back of the head. The side of the mud at the top of the head should be placed horizontally.
Use a wooden block to gently tap the slime to make it solid, and evenly beat around the head to make it a rectangular shape. Then use a small piece of mud to fill the gap between the mud strips and take some slime in your hand. The wooden sculpture tool scrapes a small amount and fills it in the hollow gap. At the same time, determine the position of the lower jaw, draw a horizontal line below the top of the head, with the long handle of the sculpture tool toward the neck, pull out about 2.5cm, and then go down to the base direction, cut the neck. Remove excess slime and create a flat surface under the jaw and lower jaw. At this time, the neck should be kept at a considerable width with the head and then narrowed later. Continue to use the wooden sculpture tool and cut some slime at the back of the neck to distinguish the neck from the head. At this time, the proportional relationship of the head should be examined, that is, whether the height from the bottom of the lower jaw to the forehead is equal to the thickness of the forehead to the posterior forearm. At the same time, it must be ensured that all the opposite sides are parallel to each other, and all the protuberances are flattened with wooden blocks.
The wax figure is made into a mud, and the front side of the head is called the front plane or the front face plane, and is divided into three equal parts from top to bottom. Then draw a line parallel to the top of the head in the third of the plane, which is the eyebrow line. In order to indicate the position of the nose, draw a vertical line in the center of the top of the head, extending from the eyebrow line to the second parallel line, draw a V shape at the end of the line, and draw a parallel in the center of the third aliquot. Line, the position of the mouth.
